5 ft. Slimline™ Filler Panel
A013
The Filler Panel is an 1/8" thick aluminum extrusion used to hide the connections at the ends of the Heating Panels. It is mounted independent of the Heating Panel to eliminate the possibility of the Filler Panel creating noise or creeping off the Corners and End Caps. Filler Panels are field cut with miter saw using a non ferrous, carbide tooth blade. Field cutting is done to ensure the best possible fit and allows the Filler Panel to be installed not just in 90 degree corners, but at almost any angle desired.
Heating Panel Mounting Bracket
A014
The Heating Panel Mounting Brackets are used to mount the Heating Panel to the wall. They are made of a special self-lubricating plastic, which allows the heating panels to expand and contract with ease, therefore, eliminating the possiblility of noise. This plastic is capable of withstanding temperatures up to 400 degrees F.
Filler Panel Mounting Bracket
A015
Filler Panel Mounting Brackets are used to support the Filler Panel where it meets the Heating Panel, in corners with angles with other than 90 degrees and in flush mount installations. Also designed to eliminate the possibility of noise, these brackets are made of the same self lubricating plastic as the Heatng Panel Mounting Bracket and allow the Filler Panel to be mounted independent of the Heating Panel.
Front Cover Clip
A016
Front Cover Clips are used to hide the 3/16" gap required between the Filler Panel and the Heating Panel for expansion and contraction. They are clipped securely to the Filler Panel and can be used on both left and right connections. The Front Clip gives the installation a stylish and complete look.
End Cap
A017
End Caps are used to support the Filler Panel and give a stylish finish at doorways or to terminate runs of heat. These end caps can be used in both left and right installations eliminating the need to have two different types on hand.
Inside Corner
A018
Inside Corners are used to support the Filler Panel in 90 degree inside corners only. The top and bottom spaces are where the supply and return lines are run. The center space can be used to run a supply and return line to a hard to reach adjoining room.
Outside Corner
A019
Outside Corners are used to support the Filler Panel on 90 degree outside corners only. The top and bottom spaces are where the supply and return lines are run. The center space can be used to run a supply and return line to a hard to reach adjoining room.
3/8" Barbed X 3/8" Copper Fitting
A021
The 3/8" Barbed X 3/8" Copper Fitting is used to connect Slimline™
to 3/8" PEX
pipe.
3/8" Barbed X 3/8" Barbed Elbow
A022
The 3/8" Barbed X 3/8" Barbed Elbows are utilized to connect the heating panels to 90 degree corners.
3/8" Barbed X 3/8" Barbed Straight Connector
A023
A 3/8" Barbed X 3/8" Barbed Straight Connector is used to join or repair two pieces of PEX
or PEX AL PEX tubing
3/8" Barbed X 1/2" MPT Adapter
A024
A 3/8" Barbed X 1/2" MPT Adapter is used to conenct 3/8" PEX Pipe to a 1/2" female adapter.
3/8" Crimp Ring for Barbed Fittings
A025
3/8" Crimp Rings compress the PEX Pipe onto the barbed fittings to make a permanent connection
